Welcome to Morrison Renewables
Renewable Energy Products for Domestic & Commercial use.
A local Kentish supplier of renewable products designed to save money on your energy bills for your home and premises based in Margate, Kent. We install and maintain a range of quality products, our team of engineers and fitters can install these products quickly on schedule and to budgets quoted. Our mission is to provide a quality product that saves you money. Please contact us for more information and a no obligation visit to your home or premises were we can advise on the most suitable products, positioning and cost.
‘POWER FLUSHING’, ‘JET FLUSHING’ & ‘HARD FLUSHING’…
…are all expressions used (in the heating trade over many years) to denote the process by which heating systems are forcibly cleansed using water at high velocity, but low pressure, so that no physical damage is caused to the system.
The process can be made even more effective with the addition of powerful cleansing and mobilising agents.
The objective is to restore systems with circulation and boiler noise problems (caused by sludge and corrosion deposits) to optimum operation. Power flushing removes these deposits and the problems that they cause.
Power flushing, in conjunction with a SYSTEM PRE-CLEAN, is also an excellent way to pre-commission clean new heating systems, to remove excess flux, swarf and other debris, and the grease and oil used to prevent rusting of components before use.
It is prudent to power flush a heating system immediately before fitting a new boiler to an existing system to prevent possible future problems. Many systems are found to contain corrosion and sludge, even if no flow problems have yet shown themselves.
Existing debris is often mobilised by alterations to the system/piping and the increased efficiency of the new boiler, and may then accumulate in the boiler heat exchanger, causing noisy operation, reduced efficiency and, in extreme circumstances, failure of the boiler. The high efficiency and compactness of modern boilers, developed to minimise fuel costs and pollution, means that they are more susceptible to problems caused by debris in the system water.
A thermal camera shows the dark spots of dirt and junk in the radiator not producing heat and making your system work harder than necessary.